Door Window Lifter Glass Seal

My Account | 0 item(s) View Cart

Home > Body and Exterior Parts > Door Parts > Door Window Lifter Glass Seal

0 Review(s)

| Questions about this item? Ask here.

(See 5 Questions)

Your Price: $7.00

Free Shipping.

Part Number:05-2541-S

Quantity

Description
Customer Reviews
Questions and Answers

Seal that rides in the door window lifter channel that attaches the window to the lifter.

Q: Is this item good for only 1 window (would I need to order 4 to do the entire wagoneer)?

Asked by: Andy Stutz - 1/29/2018

A: That is correct, each seal does one window.

Was this answer helpful? 8 of 8 Customer(s) found this Answer helpful.

Answer provided by: Ryan (1/30/2018)

Q: Is this enough material to do drivers and passengers side or just one?

Asked by: Jason - 6/27/2018

A: each unit is for one window

Was this answer helpful? 5 of 5 Customer(s) found this Answer helpful.

Answer provided by: Ryan (6/27/2018)

Q: Can this be used to hold the vent window glass into the frame?

Asked by: Jeff - 5/25/2022

A: It's possible, but we haven't tried it for that specific use

Was this answer helpful? 0 of 0 Customer(s) found this Answer helpful.

Answer provided by: Ryan (5/31/2022)

Q: Is there a trick, or proper method to installing this? I am having a very difficult time trying to get this installed and am afraid I will break the glass

Asked by: Thomas Buddingh - 3/24/2023

A: Set the glass upside down (top part down, bottom up) on a towel on a wooden table. Set the seal over the glass (make sure its sat unrolled in a warm place for a few hours, helps it soften up) evenly over both sides. Set the lifter bar onto the seal and gently tap it into place. Some people have used a rubber mallet, but if you do be VERY careful and work slowly so you don’t damage / break anything. Eventually it’ll fully seat. You can use a little water in a spray bottle to help. Once fully seated, I recommend letting it sit for at least 24 hours before installing.

Was this answer helpful? 0 of 0 Customer(s) found this Answer helpful.

Answer provided by: Ryan (3/27/2023)

Q: In the exploded diagram for this item, do you have #13 & 14? This is the round circlip and washer for the pin that goes through the lifter channel? Thanks.

Asked by: Gary - 3/26/2023

A: We have this: https://www.bjsoffroad.com/Tailgate-Window-Lift-Pins-Upgraded-Clip-Design_p_2073.html

Was this answer helpful? 0 of 0 Customer(s) found this Answer helpful.

Answer provided by: Ryan (3/27/2023)