| PHONE OR TEXT: 253-320-7604 | PHONE HOURS: MON - THU, 5 a.m. - 2 p.m. PST
Intakes and Carburetors
> Edelbrock Performer 500 CFM Carburetor w/o EGR 1403
Edelbrock Performer 500 CFM Carburetor w/o EGR 1403
Questions about this item? Ask here.
See 1 Questions
Add to Cart
Review this item
Add to Wish List
Questions and Answers
Are you looking for a great performance upgrade without having to sacrifice reliability? Do you want to have more power and better sound from under your hood? If so, then this is the carburetor for you! The Edelbrock Performer carburetor is a great upgrade over the stock system, and helps get more air and fuel into your engine for greater power.
Featuring a two-piece design, these carbs are easy to adjust and upgrade internal parts without having to remove the carb from the manifold. Each carb is set at the factory and rarely need adjustments, meaning you can bolt it on and drive right out of the box!
what would be the best carb for the AMC 360 I plan on building the motor eventually and removing the egr stuff i just want it to be the motor with as few things as possible to run could you possibly tell me what i need to remove from the motor?
If you want to size a carburetor properly, here's a quick rule of thumb to carb sizing: take the cubic inches of the engine and multiply it by the peak RPM. Take that number and divide it by 3456. That gives you the peak airflow if the engine is running at 100% efficiency. Somewhere between 85% and 105% of that number is what you want. If you put the 360 at 5500 max rpm, you're looking at between 487cfm and 602cfm, approximately. Now if you have a built engine, then of course you'll need more airflow, meaning a larger carburetor. With that said, you should consider the 600cfm for your application. However, if you want the best mileage and are willing to sacrifice a small amount of performance, the 500cfm will be more fuel efficient.
Was this answer helpful?
1 of 1
Customer(s) found this Answer helpful.
Answer provided by:
All with Edelbrock Performer Intake Manifold
Aluminum housing (dissipates heat faster)
More power & reliability
Perfect for stock or mild-built AMC's
Will not fit on stock intake manifold, must use
Edelbrock Performer Manifold
Linkage adapter required:
Carburetor Insulator to Manifold Gasket
Heater Hose Fitting 1-3/4-Inch Long Stainless Steel - Made in USA!
Edelbrock Carburetor Stud Kit 1.38 Inch Height
Edelbrock Carburetor Stud Kit 1-3/4 Inch Height
Edelbrock Intake Manifold Gasket Set AMC V8
Carburetor Gaskets Upper and Lower
Browse Similar Items