Shackles Heavy Duty 1-inch lift

A: Per the description on the product page, they are sold in pairs! Answer provided by:  Ryan (3/5/2016)

A: These shackles are 2" taller than stock, to give a 1" lift. Unfortunately these will only work on 1974-later styles as the attachment points / hole diameter / width / bushings are different than earlier models. Answer provided by:  Ryan (5/9/2016)

A: No, as the rear shackles are inverted, so any "lift shackle" will actually lower the rear end. Answer provided by:  Ryan (5/31/2016)

A: These are the same width as the stock originals and fit into the stock mounts. If you are wanting to use these on a non-Full Size Jeep application, email [email protected] for more details. Answer provided by:  Ryan (7/25/2016)

A: They feature the same opening width between the ends as the factory set-up. Answer provided by:  Ryan (4/21/2017)

A: They are listed as a different size, diameter, etc. Answer provided by:  Ryan (5/19/2017)

A: They are 2" taller than stock bolt to bolt. Answer provided by:  Ryan (9/26/2017)

A: No, you will need to use these:
http://www.bjsoffroad.com/Heavy-Duty-Shackle-Bushings_p_1798.html Answer provided by:  Ryan (4/13/2018)

A: These are 2" taller than factory, which gives a 1" lift. Answer provided by:  Ryan (9/4/2018)

A: Yes, these will raise the front. In the rear, since the shackle is inverted, the longer shackle would lower it. The only way to raise the rear would be taller springs or steel blocks (which we don't sell or recommend). The lift shackles are to help raise the front when you have a heavy front bumper / winch combo, or a heavier engine than stock, etc. Answer provided by:  Ryan (9/10/2019)