Wiper Switch 1979-1985 with Intermittent Wipers

A: They are different and not interchangeable Answer provided by:  Ryan (3/2/2016)

A: The switch will either be non-intermittent, and will have three positions that are solid (off, low, high), or it will be intermittent, and will have three positions plus a sliding scale rotation (off, low, high, and in the other direction the switch will rotate for a while, as if you were turning a door knob). Another way to check is to look under the dash, and near the back of the switch will be a small square black box that is approximately 3" x 2" x 2" and will be plugged into the switch. Answer provided by:  Ryan (7/21/2016)

A: Yes, ours is a replacement for that unit. Answer provided by:  Ryan (4/24/2018)

A: Yes and no. You would need to install this switch, but you would also have to find a wiper delay module (used) and install that between the factory plug and the new intermittent switch. Answer provided by:  Ryan (6/6/2016)

A: You would need this and a used black control box under the dash. Answer provided by:  Ryan (11/22/2019)

A: Not at this time, you'll have to source the bezel and nut used somewhere. Answer provided by:  Ryan (1/14/2021)

A: The product does have a ground wire. It shouldn't be a problem though, just ground that wire. As for the long shaft, those are not being reproduced. The only ones we have are the short style. Answer provided by:  Amanda (6/17/2021)

A: To our knowledge, no. We do not specialize in CJ's, so we cannot guarantee fitment. Answer provided by:  Amanda (11/23/2021)