Wiring Kit Universal 12 Circuit

$190.00

Part Number:

11-2092-12

Shipping:

Calculated at Checkout

Product Details

Don't try to repair your old burned up wiring harness, start fresh with one of our new universal wiring harnesses! The fuse block is pre-terminated so all you have to do is run the wires where you want them! These harnesses use GXL 125 high temp cross linked polyethylene jacketed wire that is grease, oil, gas and acid resistant! Each wire is labeled every 5" on its entire length so checking a circuit is easy! This harness replaces the entire harness front to rear (you must reuse your original connectors or make your own).

Headlight
Turn Signal
A/C and Heat
Electric Fan
Windshield Wiper
Gauges
Coil
Radio
Accessory
Brake
Hazard
Horn

Fits All Full Size Jeeps
Universal (not factory replacement)
Reuse factory connectors, solder to new harness
Replaces entire harness bumper to bumper

Reviews (1)

Dingalingdangadangalonggong

5
Posted by gordon bradford on Mar 21st 2016

This harness is top notch for a universal. The Good: 1) Fuse block snaps right into the 79 J-10 bulkhead connector, just like factory! 2) Wires are clearly labeled along the length of the wire, not just tags on the ends. 3) Wires are pre-bundled for where they go, makes sorting it out prior to install super easy. What could be better: 1) Wire labeling rubs off, awesome for install, but may make troubleshooting challenging in the future. 2) No bulkhead connector. I don't call these "pros and cons" because I'm sure the "could be better"s are available on more expensive harnesses. This harness is definitely a value and I have no regrets! I bought a 22pin weatherpack bulkhead connector and cut out the burnt up and corroded spade connectors from the factory bulkhead connector. I used a 4"x4" steel sheet on the firewall side, held in place by the factory bulkhead connector bolts and mounted the weatherpack in that. G2G!

Write a Review